The Next step was to figure out what the other 13 pins did that lead to the small edge connector. Someone with a little experience could have likely figured this out in 10 minutes but I chased each wire and made a wiring diagram.
 |
| I removed all the components from the spare side of the machine (remember this was a twin, so I have an extra set of replacement parts). I cut open the harness and traced each wire. (I spent slightly more time than 10 minutes.) |
 |
Siedel Pokereno Wiring Diagram/Schematic.
The 13 pin edge connector is on the right edge. This is where the Arduino will operate the Pokereno. |
The significant thing about the Pokereno is the backglass lamps all work without the logic board plugged-in. They are hardwired to the power supply. If one lamp is out, replace the bulb. If none of the lamps light, replace the power supply.
No comments:
Post a Comment